This article will introduce how to safely use our benchtop sander machine. Including two processes: 1. PRE-OPERATIONAL SAFETY CHECKS & 2. OPERATIONAL SAFETY CHECKS.
PRE-OPERATIONAL SAFETY CHECKS
1.Ensure you are familiar with the operation of the ON/OFF switch and emergency stop.
2.Check the sanding disc table is set not more than 2mm from disc.
3.Check the linishing belts and discs are both in a serviceable condition.
4.Ensure the operator be positioned out of direct line of abrasive belt at all times.
5.Ensure dust extraction is on before operating either sanding machine.
6.Faulty equipment must not be used.
OPERATIONAL SAFETY CHECKS
1.Both components of this combination machine should NOT, where possible, be operated simultaneously.
2.Allow machine to reach maximum revolutions before operating to avoid overloading.
3.NEVER attempt to sand very small items, lift or tilt the material while sanding.
4.Always place material on the table and on the downward side of the disc travel to hold it securely on the table surface.
5.Hold material firmly against stops or table before applying pressure on abrasive disc or belt.
6.Keep fingers clear of sanding disc or belt while sanding.
7.NEVER attempt to or try to sharpen metal items.
8.NEVER leave the machine while it is running.
9.Before making adjustments switch off and bring the machine to a complete standstill.
