Scroll saw tasks
Challenge yourself with the many delicate arms of this design.
|
（1）
Print at actual size for 8" (20.3cm) dia. or at 125% for 10”(25.4cm) dia. |
|
（2）
Print at actual size for 8" (20.3cm) dia. or at 125% for 10" (25.4cm) dia. Recommended wood: Baltic birch, 1/4 "-1/2"(6-13mm) thick, or any wood of choice,1/2"-3/4"(13-19mm) thick, 8 1/2'"(2l.6cm)or 10 1/2"(26.7cm) square when increasing actual size of pattern to 125% for 10"(25.4cm) dia. Recommended drill bits: 3/64"(1.2mm) & 1/16" (1.6mm) or #56 ( 1.2mm) 4(1.6mm) for interior cutouts.Flower center holes (6 places):3/8” (9.5mm) Recommended blades:#3一#5 reverse tooth for Baltic birch; #5 reverse skip-tooth or reverse tooth for hardwood;alternatively, use #0- #1 spiral Notes/special instructions: Pay special attention when cutting the butterfly antennac, as this is a fragile area to cut. Recommended finishing:For most woods, Danish oil or oil of choice; for Baltic birch plywood, acrylic paints of choice and clear protective brush-on or spray-cat finish.For exterior use, spar urethane or exterior-grade clear-coat spray. |
|
（3）
Recommended wood: Hardwood of choice,1/2"—3/4"(13-19mm) thick, 8 1/2”(21.6cm) square Recommended drill bits:1/16” (1.6mm) Recommended blades: #5 reverse skip-tooth or reverse tooth Notes/special instructions: Only an even and steady hand is needed for all interior cuts. Recommended finishing: Danish oil or oil of choice. |
